Arsenalas

TGM
A3 ETU Submachine Gun Replica

TGM A5 pistol replica made of high-quality polymer and metal. Elements such as
the receiver, iron sights, magazine, external barrel were all made of metal.
The pistol grip together with the bottom receiver, handguard and adjustable
stock were all made of nylon polymer. Steel parts include the magazine and
small elements such as the mock bolt carrier or the flash hider latch. The fire
mode selector was adapted for use by both left- and right-handed users.

In order to access the hop-up chamber one must first pull back the charging
handle and leave it in rear position.

The replica stands out from other
G&G replicas in terms of internal parts used as well as the quality of
exterior craftsmanship. The replica features two electronic systems: MOSFET system
located in the stock slide and a G2 ETU (Electronic Trigger Unit) system.
Both systems extend the lifetime of the replica and improve its parameters like
the trigger reaction time and rate of fire. The MOSFET system enables the
programming of 3-5 round bursts, informs about low battery charge and a
damaged gearbox. 

The handguard contains 3 RIS 22 mm mounting rails, each 120 mm long. The
set also includes a top RIS rail, mounted on the receiver. The battery is
stored inside the handguard. In order to connect the battery, it is necessary
to remove a pin located in the front of the handguard. 

The set does not include a battery
or a charger.  

The set includes:

– replica
– a magazine
– RIS mounting rail
– QD tactical sling swivel