Aprašymas
Trigger Magnetic Resistance Clicker from Perun for Hybrid V3 Processor Units
Trigger Magnetic Resistance Clicker is an accessory designed for use with Perun V3 Hybrid processor units. This product provides a real trigger resistance feel similar to that of real firearms, making it ideal for those who want a bit more than just a shot from their airsoft gun.
How does the Clicker work?
Clicker uses a magnet and lever to simulate the so-called wall, which is a method that reduces possible component wear (as happens with spring-based trigger resistance simulations) and provides an unmatched feel of resistance, break, and trigger reset.When the trigger is pulled, the metal part separates from the magnet with which it is in contact when at rest. Due to the rapid decline of the magnetic field strength with distance, the result is a relatively sharp break in resistance.The break force is increased by using the lever. When released, a distinct audible reset of the trigger is heard, as the metal part gets very close to the magnet again and immediately attaches to it.
Installation and Adjustment
1. Installation
To install the Clicker, simply remove the V3 Hybrid magnet holder from the trigger and the mechanical safety lock from the gearbox.Insert the Clicker into the gearbox.There may be some resistance during the assembly of the two halves of the gearbox because the Clicker must remain absolutely stationary inside the shell to provide a pleasant trigger pull. Therefore, it was designed to fill the gearbox space as tightly as possible.
2. Break/Resistance Force Adjustment
To adjust the trigger resistance force, select one of the two pivot pin holes for the Clicker and change the position of the return spring.The default setting is for a hard trigger resistance, but you can change it to a soft resistance by moving the pin to the second hole on the Clicker, then remove the screw holding the return spring in the middle position and mount it in the left fitting.
3. Pre-travel
Pre-travel is th..
