Description

CM040J assault rifle replica (ASCU version)

The family of CM replicas based on popular Russian assault rifles has been complemented with a new line – modified with a range of “tactical” accessories, increasing ergonomy and possibilities of configuration of this classical design.

The replica has been perfectly matched, there are no backlashes here, the product was thoroughly finished in mat, black colour. Steel, aluminium, alloy of Zn and Al as well as polymers were used in the construction process. The receiver, the folding stock, the dust cover, the trigger guard and the fire selector were made of steel. The gas pipe together with the RIS rail were made of aluminium, whereas the front and the pistol grips are of plastic.

The replica has got a frame stock folded at side. On the gas pipe there is a 22mm RIS mounting rail, which allows to equip the rifle with additional accessories. Moreover, on the left side of the body the AK side rail was located – this allows to mount dedicated scopes or additional RIS rails. On the right side there is a fire selector, distinctive of AK

Disassembling of the replica and mounting additional accessories is eased by the design itself based on pins and levers – similar to the real steel and other AK replicas in the popular standard VFC. The outer barrel ends with a 14mm right-hand thread, where the flash hider was mounted. The replica”s battery is located under the dust cover (included in the set).

The replica is driven by a very reliable and easy to upgrade gearbox v.3 with a strengthened frame. A set of steel racks , steel 7mm slide bearings, a strengthened piston and spring slide  were mounted inside. Efficiency is ensured by a 455mm long inside barrel and a tight metal Hop-up chamber.

The replica goes together with a plastic hi-cap magazine with capacity of 500 BBs

The ASCU is a two-part electronic module ( the control module and the sensor module ) which, upon being installed in the Airsoft replicas, significantly improve their operation. The traditional joint module was replaced with a sensor module which monitors the actual position of the piston thread-wheel, the firing mode selector lever and the trigger. The gathered information is sent to the control module – in which the software located in the processor analyzes it and controls the replica’s motor with the use of the MOSFET active break.

ASCU Gen. 3+ includes the following upgrades: 

– added polymer padding to the circuit boards, protecting them from damage during installation
– obsolete short-circuit software removed, making shots in semi-auto much faster
– every pull on the trigger results in a single shot, new system prevents any double-shots
– new cut-off lever and selector plate designed specially for the ASCU
– new, thicker wires
– no need to dremel or modify the reinforced gearboxes.

The ASCU improves the operation of a V.3 gearbox and makes that the replica equals the more expensive replicas and the more sophisticated PTW class replicas. The ASCU system monitors the operation of the replica no matter the speed of squeezing the trigger and is responsible for the full cycle of the piston’s operation, both in the semi-automatic and full automatic firing modes. The piston stops in the starting position after each shot.

The ASCU is equipped with the Low Drain Protection system which is specially designed to secure the lithium-polymer (LiPo) batteries from being damaged.

In case of any emergency, the ASCU stops the firing mode in the replica and, therefore, secures the inner elements from further damage.

The ASCU is easy to install in the replica which is equipped in the V.3 gearbox. Most of the models does not require the modification of the airsoft rifle’s original parts. Yet, in some cases, some minor changes may have to be introduced – thanks to this the installation process will be completed without any problems.

The set includes:

– replica
– magazine
– battery
– battery charger