Description
CM052A machinegun replica (ASCU version)Â
The machinegun replica is made fully of metal and wooden elements. The replica’s body, the flash0hider, the dust cover, the gas-pipe dummy and the bipod are made of steel and the other metal elements are made of ZnAl. The stock which holds the battery and the front-grip covering panels and the pistol grip with the magazine are the plastic made elements.
The long barrel (455mm) ensures a great precision of shots, the muzzle velocity of 420 FPS – a great range and the hi-cap type magazine holding 800 BB pellets ensures us that we will not be short of ammunition in case of a firefight. These features make the replica a perfect support weapon for any airsoft team.Â
The Hop-up chamber is made fully of metal while the whole mechanism consists, inter alia of a reinforced steel gearbox frame equipped with 7mm ball bearings, steel reinforced thread-wheels and directional piston head. The replica is by default equipped with a M125 main spring that is located on a reinforced ball bearing spring guide.
The full compatibility with the classical magazines allows not only to use the magazines of your friend while an exhausting firefight, but also to use this replica as a sharp shooter’s weapon. The bipod which folds alongside the barrel will do its job in both cases, nevertheless, it is possible to detach the bipod with only little effort in order to lower the replica’s weight The replica ‘s stock may be folded in order to transport the replica.
The set includes:Â
– the replica
– a magazine
– a battery
– a charger
The ASCU is a two-part electronic module ( the control module and the sensor module ) which, upon being installed in the Airsoft replicas, significantly improve their operation. The traditional joint module was replaced with a sensor module which monitors the actual position of the piston thread-wheel, the firing mode selector lever and the trigger. The gathered information is sent to the control module – in which the software located in the processor analyzes it and controls the replica’s motor with the use of the MOSFET active break.
ASCU Gen. 3+ includes the following upgrades:Â
– added polymer padding to the circuit boards, protecting them from damage during installation
– obsolete short-circuit software removed, making shots in semi-auto much faster
– every pull on the trigger results in a single shot, new system prevents any double-shots
– new cut-off lever and selector plate designed specially for the ASCU
– new, thicker wires
– no need to dremel or modify the reinforced gearboxes.
The ASCU improves the operation of a V.3 gearbox and makes that the replica equals the more expensive replicas and the more sophisticated PTW class replicas. The ASCU system monitors the operation of the replica no matter the speed of squeezing the trigger and is responsible for the full cycle of the piston’s operation, both in the semi-automatic and full automatic firing modes. The piston stops in the starting position after each shot.
The ASCU is equipped with the Low Drain Protection system which is specially designed to secure the lithium-polymer (LiPo) batteries from being damaged.
In case of any emergency, the ASCU stops the firing mode in the replica and, therefore, secures the inner elements from further damage.
The ASCU is easy to install in the replica which is equipped in the V.3 gearbox. Most of the models does not require the modification of the airsoft rifle’s original parts. Yet, in some cases, some minor changes may have to be introduced – thanks to this the installation process will be completed without any problems.
Reviews
There are no reviews yet.