Description

Professionally made mosfet designed for airsoft electric guns (AEG).Device increases gun rate of fire and battery holds longer, than with basic wiring.
IMPROVEMENTS OVER MICRO MOSFET II:- Designed for higher current loads- Can be soldered directly to the minus contact of the T-Plug connector
SPECIFICATIONS:- Very small device dimension, it fits nearly everywhere- Devices without wires, you can use max. 1,5qmm (AWG16) power wires and 0,5qmm (AWG20) signal wires- suitable for service center, if you are not familiar with soldering to the circuit board, choose device with wiring and accessories.- Designed for spring up to M170 (equivalent for current 90A single shot fire or 35A burst fire for max. 30s). For higher load please use Mosfet II- Specified for common batteries up to 17V (Ni-xx 8.4 – 12V, lipol 7.4 – 14.8V)- 5 wires connection- positive wire isn’t connect into device- device size 16×6,4×3,5mm- No current consumption in the idle mode- No sparking on switch contacts- In auto fire mode piston stops in random position due the mechabox design- For right function is necessary to have a functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block, as it has the standard gearbox
DEVICE INSTRUCTIONS: you can download installation manual in English here [PDF, 673.34 kB]PACKING: device, heat shrink tube and installation manual in English
WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!
WIRING CONNECTION INTO THE GUN: