PL-2 Valkyrie XHP35 Flashlight

A firearm flashlight powered by two CR123A batteries that thanks to Cree
XHP35 HI diode provides a beam of light with a strength of 1200 lumens
and a range of 235 meters. Valkyrie is equipped with a mounting
rail compatible with 22 mm standard (Weaver / Picatinny / MIL-STD-1913).
A system of steel clamps allows for the rapid attachment of the flashlight to a
weapon.

The casing of the flashlight was made from aerospace aluminum covered
with hard anodizing in black color. In addition, the head of the
flashlight is protected by steel crown in the front. Such
construction allowed to increase the resistance to fall damage to a height
of 1 m.  Implemented seals guarantee IPX7 Water
Resistance. Batteries are installed after the removal
of the flashlight’s head.

The heart of the flashlight consists of advanced electronics which steer
the power drain directed to the XML diode. Thanks to that, the flashlight can
cast a light with the same power until the complete discharge of the battery.
Active Thermal Management system protects the diode from overheating whilst
operating in the most powerful mode (1200 lumens). After 90 seconds, it
reduces the voltage and stabilizes the light on a level of around 600 lumens.
After the deactivation of the flashlight, cooling off and reactivation, the
flashlight will once again operate in the most powerful mode.

The flashlight is turned on using a comfortable switch located in the rear
part. The switch is double-sided, which allows the flashlight to be
used by both left- and right-handed Users.

Modes of operation/operation time (2 x CR123 battery):
– 1200-600 lumens / 1.5 min + 70 min
– strobe / 70 min

The
flashlight comes with two CR123A 1600 mAh batteries.

Specification:

Light Source: Cree XHP35 diode 
Effective Range: 235 m (wide beam)
Power Source: 2 x 3 V CR123 batteries
Casing: Aerospace aluminum with hard, type III anodizing
Switch: Electronic (double-sided)